Understand the exposure
Identify the host and contractor responsibilities, scope, competence, access, utilities, permits and adjacent work. Include subcontractors, temporary arrangements and shift relief. The actual combined work system matters: a change by one team can invalidate the protection assumed by another.
Design and establish protection
Plan work so incompatible activities are separated or prevented from overlapping. Establish a shared picture of boundaries, required controls, emergency arrangements and who can approve changes. Verify competence and understanding for the assigned task; a supplier approval or induction record does not establish every individual’s task authorization.
Verify before and during work
The control owner translates these teaching prompts into asset-specific performance requirements and a safe checking method. Record the actual evidence, its scope and the responsible role. Missing evidence remains Unknown; a required control that fails or cannot be verified creates a STOP condition for dependent exposure.
- Combined work and permits are mutually compatible for the current scope.
- Responsibilities, competence, boundaries and emergency arrangements are understood.
- Changes and handovers preserve protection for every affected group.
Practise a decision
A contractor relocates welding close to an area where coating work is underway. Both crews hold permits. What question comes before allowing the new location?
Feedback: Check whether the changed work remains compatible with the assessed conditions and accepted protections. Stop affected exposure and coordinate competent reassessment of atmosphere, ignition and other interfaces. A permit for the earlier location is not proof for the new arrangement.
Changed condition: The revised plan is accepted, but a relief worker arrives after the briefing. Confirm that person’s scope, understanding and required authorization before assignment. A briefing completed by the original crew does not automatically transfer to someone new.
Support the people doing the work
Schedule pressure and organizational boundaries can hide assumptions. Ask each group to explain who controls the interface and how a change is communicated. Use exact status read-back where misunderstanding could change exposure, and preserve unresolved STOP conditions during handover.
Transfer the learning
Choose one relevant task and explain the hazard, protective function, evidence needed and condition that would stop the work. Then identify who can resolve a gap and what must be rebriefed before designated restart. Use an approved classroom or tabletop example; do not create a hazardous condition for assessment.
This topic is educational guidance, not an approved equipment procedure or a competence certificate. C8-06 is the stable program identifier. Local technical acceptance, emergency capability and understood instructions remain prerequisites for actual work.
Learning material for team discussion. Apply your site’s approved procedures, competent-person assessments and applicable requirements to actual work.
Take this learning to the team
Choose the language and format for your session. Review drafts with your safety and operations leads before adapting them to local work. A download is learning material, not authorization to perform a hazardous task.
English resources
- Learner practice workbook (DOCX, 11 KB) ↓Teaching and local review edition · v1.0
- Critical 8 one-page recaps (PDF, 732 KB) ↓Design and review draft · v0.13
- Critical 8 teaching slides (PPTX, 3.9 MB) ↓Design and review draft · v0.13
Sources & further reading
Use the original source to check its scope, terminology and current requirements.
